Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
618 Posts
Discussion Starter · #1 ·
I'm in the process of building new doors for my plain white kitcnen cabinets. The new doors have a white raized panel[MDF] with a clear pine frame. They are turning out really nice. I'm using a PC 9690 router in a homebuilt table, HF cabinet makers bit set [$19.99], and a speed control also from HF.
The instructions with bits say 8000 rpm max. But if I turn the speed control even half way down I seem to lose all the routers power. So I run allmost full speed and route the panels in 4-5 passes without any problems.
Is this just the way speed controls work. Or is there one that can reduce speed without just cutting power.

Thanks, Rusty
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top