Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter · #1 ·
New custom built router table. Top is 1 1/2 inch MDF with 3/4 inch oak edge. Top is formica covered. Plate is set up for Hitachi M12V. I have a couple blanks that you can drill for your router. Sides and bottom are 3/4 inch oak ply. Very solid unit. Top is 16" X 30". $125.00

Email me for more photos.
[email protected]
 

Attachments

·
Banned
Joined
·
11,934 Posts
It might help you sell this if people knew where in the world it was. Shipping can be a deal killer.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top