Router Forums banner
1 - 1 of 1 Posts

·
Marine Engineer
Doug
Joined
·
4,962 Posts
Bill,

Think about the work you are going to be doing. If it is mainly small stuff, I like things a little higher, so I feel closer to the work, more control, etc.

If you are doing a lot of big stuff, it might be better to be a little lower than average, to line up with existing cabinets, sawhorses, or other handy items that can serve as stock supports or an outfeed table.

Like everything else, personal preference is a big factor. The only good thing, if you find the table a little low after you build it, you can build a handy riser platform to set it on......

Good luck, and make sure you post a picture when you are done.

As to your other question about getting what's in your brain out on paper, I cannot provide any help. I usually end up accidentally dumping my ideas into the "recycle bin" instead of sending them out to the printer....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top