Router Forums banner
1 - 1 of 1 Posts

·
Registered
I always like to trade....always like to sell
Joined
·
330 Posts
If there are no adjustment screws to jack the plate level with the top surface you can add some similar to this -
View attachment 401360
I've had leveling screws strip out in press-board before on my router table top and I drilled a 3/8" hole where the screw was and inserted a oak dowel with glue. Much better than screws in press board..This is a technique I learned many many years ago for repairing stripped out door hinge screws..
 
1 - 1 of 1 Posts
Top