Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
8 Posts
I use an upside down "T" shaped 2x4 glued to the bottom of Bob & Rick's table to attach it to a Workmate (with the lower legs folded in). This gives a nice hight and a sturdy surface for my routings. I use the same set up for my jointer planer and use both on the same workmate. It saves some space too.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top