My Version of the Oak Park Router Table
This is my version of the Oak Park router table.
All dimensions are basically the same as the print, the only exceptions were the large drawer and the three drawer fronts (one drawer, and two bit trays, one for 1/4" and one for 1/2").
I used one 8'x4' sheet of 5/8" laminated particle board plus one 6'x12" piece of laminated shelving. Home Depot was kind enough to chop up the 8'x4' to the dimensions on my cut list.
At all joint areas, I routed off the laminate layer to ensure good bonding of the glued surfaces.
I also added a shelf in the lower cupboard and a switchable power outlet.
This is my version of the Oak Park router table.
All dimensions are basically the same as the print, the only exceptions were the large drawer and the three drawer fronts (one drawer, and two bit trays, one for 1/4" and one for 1/2").
I used one 8'x4' sheet of 5/8" laminated particle board plus one 6'x12" piece of laminated shelving. Home Depot was kind enough to chop up the 8'x4' to the dimensions on my cut list.
At all joint areas, I routed off the laminate layer to ensure good bonding of the glued surfaces.
I also added a shelf in the lower cupboard and a switchable power outlet.
