Router Forums banner
1 - 6 of 6 Posts

·
Retired Moderator
Joined
·
2,093 Posts
Discussion Starter · #1 ·
I have a 690 porter cable router mounted on a grizzly router table my problem is the molding bits that I have are to big to put up through the bottom and to hard to tighten from the bottom would be okay to cut the insert hole on the table a little bit bigger. :confused:
Glenmore
 

·
Retired Moderator
Joined
·
2,093 Posts
Discussion Starter · #5 ·
Oh boy sorry I forgot to mention that the router table I have is a bench top model I can't use a router base plate the hole is only so big. So can I cut the opening a little bit bigger without messing it up.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top