Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
42 Posts
Discussion Starter · #1 ·
I have been wanting to build a router table or make an insert for my table saw. I happened upon this insert on HD website model#40-070. Internet #205414495. I would like to mount it on my Ridgid R4512. Anyone have any experience with this insert? The Ridgid table saw has tracks for the fence at the front and back that are made of aluminum. This insert is cast iron, can it hold the weight?
 

·
Registered
Joined
·
42 Posts
Discussion Starter · #3 ·
I was thinking of putting a DC Port in/under it. So I would have to box it in, thus giving room for added storage. I will have to make the legs adjustable as the table has casters with a peddle to move it around. This Ridgid table saw weighs 270ish lbs., I don't think it would topple over, but I am concerned with the wing rails. Thanks.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top