Router Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter · #1 ·
I am in the process of building a sweet router table very similar in size to the Bob & Rick's. I believe B & R's is 16" X 30". After I got the top done, 16" seem's like a pretty small width for a table. Most of the things that I do will work fine.

Does anyone find that this size of a table is too small? I went this route so I could use some of the techniques and jigs I see on the router workshop program.

Thanks,

Deck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top