Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
208 Posts
If your going to build a horizontal router table.....make a decent one because not only will it handle verical panel raiser bits, but will also function as an edge jointer, simplifies sliding dovetails, make nifty blind dovetails for joining table legs & rails, machining breadboard table ends, & on & on. A good table can be made in a weekend. A good plan is available in a book by Bill Hylton "Woodworking with the Router".

Lee
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top