Router Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi Guys. My name is Jim. I do some woodworking as a hobby, hopefully it will turn into extra money to supplement my retirement. I've been doing this since I was about 15 years old. I've been a member for a while, but, this is just my second post. Hope I'm doing it right. Just a few images of my new router table I built. It's made with Kreg legs and the Clamping table top. As you can see it is dual purpose. I took the top and routed a hole in the center for the router insert. This way I have only one table which I can rout on and also use the same for clamping up frames and doors. Saves room in the shop which I don't have a lot of. Hope you enjoy looking at them.
 

Attachments

·
Premium Member
Joined
·
17,427 Posts
Nice work Jim . I was wanting to do something simular to save space . I don't see a lot of combination router table assembly tables built , so the is nice to see
 

·
Registered
Paul
Joined
·
1,860 Posts
She's a beauty, Jim. Is that a Kreg switch cover plate? ;)
 

·
Premium Member
Joined
·
17,427 Posts
I was a little concerned about cutting into the top, but it came out good.
That's always been my concern to . To ruin it after doing all the lamination and work to get to that point .
Looks like you nailed it though :)
 
1 - 11 of 11 Posts
Top