[cfm]

Curious if I could get some ideas about the pros and cons about the layout of different router table configurations.

For example : Insert plate located in the center of the table vs the insert plate located off center closer to the table top edge.

-and/or-

Different sizes of table top recommended.

Thanks, this is my first and have high expectations

 

[pmspirito]

I am starting one like Bob and Ricks. But I plan to make it a bit wider both front to back and left to right. No special reason other than i have room for it and i can cut it down if i don't like it. The extra length allows a longer jointer fence to be used.

 

[Spacemanspiff]

Mine is rectangular and the insert is in the middle of the table and I like it like that. No particular reason why either!! My table size is 700mm wide by 500mm deep. Seems to be big enough to me.

Hope this helps,
Aaron

 

[cfm]

I am starting one like Bob and Ricks. But I plan to make it a bit wider both front to back and left to right. No special reason other than i have room for it and i can cut it down if i don't like it. The extra length allows a longer jointer fence to be used.

Solid suggestion, I forgot about the Jointer option in considering a more compact functional table. I have the jointer on a larger table - but, it takes up too much room. Thanks again