Router Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
little help. can some tell what type of router to use with the milescraft pro 1212, i just got a roybi but the base plate wont line up. thanks
 

·
Super Moderator
John
Joined
·
6,832 Posts
Hello and welcome to the router forum.
Not familiar with what you need but someone will belong to help
 

·
Super Moderator
Joined
·
5,771 Posts
little help. can some tell what type of router to use with the milescraft pro 1212, i just got a roybi but the base plate wont line up. thanks
I mounted the base on the little DeWalt compact Router (DW611) plunge base. I had to drill one hole in order for the holes to line up.

I might add that I haven't taken it off. I like the fact the base is larger than the factory DeWalt base plate.
 

·
Retired Moderator
Joined
·
16,385 Posts
Hi and welcome. It's not uncommon to have to drill one or more holes in after market plates. Lots of older stuff came drilled for either PC or Bosch but often not anything else.
 

·
Official Greeter
Ross
Joined
·
8,320 Posts
Welcome to the forum.
 

·
Registered
Joined
·
1,535 Posts
Mine is mounted on a Bosch Colt. If 2 holes line up--that is enough to hold, or mark/drill a third. Like Mike--I just keep that mounted to the base plate.
earl
 
1 - 6 of 6 Posts
Top