Router Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
hi everyone

can any one help i have a fox router table with a Erbauer router fitted
really bad vibration when in use
is there any pad i can fit between router and table:(
 

·
Registered
Joined
·
23,786 Posts
HI beard4460

Let me say right off the bat you should NOT have any vibration.. :( or to say very,very little..

You may want to make sure the router is in place right and tight in place.

Chuck up a 1/4" dowel pin and see if you have the same type of vibration if so pull the router out and check the collet and the bearings..if they are damage replace them..the router is made to spin very true..on dead center..if it's router router plate that is not right put in some small 1/8" x 3/4" dowel pins in the two corners to keep it from moving around,but don't screw it down with screws, you want to pop it out from time to time..



=========



hi everyone

can any one help i have a fox router table with a Erbauer router fitted
really bad vibration when in use
is there any pad i can fit between router and table:(
 

·
Registered
Joined
·
10,671 Posts
Greetings and welcome (your name here) to the forum good to have you here. You won't get any better information than from BobJ. I sure seems if it is called a router he is "dead on right" about it.
 
1 - 4 of 4 Posts
Top