Router Forums banner

routing a bearing edge on drum shell

5733 Views 2 Replies 3 Participants Last post by  Spacemanspiff
hi, I'm going to make my own drum and after creating the shell I'll need to create a 45 degree bearing edge. I am new to this so I need a little help. What type of router bit should I use for this. Would it be one called a chamfer bit or would it be something else?
1 - 3 of 3 Posts
Yes you have the right bit. The chamfer bit with a bearing will make the 45 degree on an irregular shaped edge.
Hey UNsound ... I would like to see pictures of this once you have finished ..

Thanks
Aaron
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top