I move the fence away from the bit. This way you are still feeding into the bit, and not climb cutting, which can pull the bit away from you.
You could also set up your fence with a 1/4 inch shim. Make the first cut, which will be 'balanced' with stock on both side of the bit. Then, pull your shim and make the cut again.
It has worked for me in the past, maybe another can explain it a little clearer if needed.
You could also set up your fence with a 1/4 inch shim. Make the first cut, which will be 'balanced' with stock on both side of the bit. Then, pull your shim and make the cut again.
It has worked for me in the past, maybe another can explain it a little clearer if needed.
