Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
How can I make a decorative groove on a table apron that has an inside curve? Even with an edge guide I think there it would be hard to keep the groove parallel with the edge. Any suggestions?
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
This is a rectangular table with aprons about 4 inches deep. At the bottom of each apron is a decorative up-curve. I want to make a groove along the flat front of each apron about 3/8 to 1/2 inch up from the curved edge.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top