Router Forums banner
1 - 1 of 13 Posts

· Registered
132 Posts
Try use Spiral bits when cutting plywood. You can use single or double flute bits, but as said earlier, use a down cut. Since you're not going very deep a down cut would be the way to go. You won't find the Spiral bits at any of the local hardware stores as they are usually used on CNC machines. If you're close to a Woodcraft or Rockler store they will have those type of bits.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.