Router Forums banner
1 - 3 of 7 Posts

· Registered
3 Posts
Discussion Starter · #4 ·
Sorry, I should have explained a bit more.
I am working on the mission mantle clock from Klockit. The top plate and bottom plate have convex profiles on the ends and front- 3 edges of the 4 need this convex. The back does not. Just on one face of each board. I am attempting to do this on my router table with a Bosch 1617evs router. Thanks for your help.
1 - 3 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.