Joined
·
16,386 Posts
Or use a push block to push the board past the bit as shown in this video at the 5 minute mark: https://www.youtube.com/watch?reload=9&v=hHnLvps8968
I usually just grab a leftover piece of ply or mdf that's from 6-10 inches square and use it to push my work through. That keeps it square and and reduces the chance of blowout to near zero. Clamping the board to your work is about 99%+ foolproof.
I usually just grab a leftover piece of ply or mdf that's from 6-10 inches square and use it to push my work through. That keeps it square and and reduces the chance of blowout to near zero. Clamping the board to your work is about 99%+ foolproof.
