Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
12 Posts
I've routed several kinds - up to 3/4" router bits - full speed.
"Lexan" - produced long spider-web strings
Acrylic - routs well
UHMWPE - difficult but doable. Must push/move hard against the bit - almost to the point where you think you will break the bit! Not surprising - the stuff is designed to reduce friction.

* Always on a router table
* Always small cuts (1/8") at a time
* Always keep the plastic moving to avoid melting
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top