Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
For economical reasons I made several adjustable bookends for Christmas presents. I was satisfied with the overall appearance, but I had to do some serious sanding to get rid of router tearout.

I realize that I am routing edge grain. There are probably some good ideas on how to use a 1/2 inch roundover bit and reduce the end grain tear out on 1/2 inch Baltic Birch Ply. Can anyone help?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top