Router Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
Can anyone help with an adapter plate to make my Router fit my table saw.
Ryobi router is an ERT 241200
and the Ryobi table saw is an ETS 1526AL
Thanks in advance
:x
 

·
Retired Moderator
Joined
·
16,385 Posts
Adam is there already a cutout in the table wing for a router? I'm not familiar with that model.
 

·
Registered
Joined
·
30 Posts
Discussion Starter #3
There is Chuck but nothing lines up.
I'd like to buy one, but can't find one. May have to make it...
 

·
Retired Moderator
Joined
·
16,385 Posts
I had a look at them and it doesn't use a plate. The top is cast and machined for a specific router or series of routers to be bolted directly under it by the looks of it. Sears sold lots of routers made by Ryobi, anything starting with 315., and they offered tables and only the Ryobi made routers matched the bolt pattern.

To be honest, unless you are short of space, it's not a great idea to have saw and router in one. Table saw fences aren't made for routers because mist of the bit normally needs to be behind the face of the fence and there will be times when you need the full surface of the saw but you also have the router set for some operation that you don't want to have to reset it for.
 
1 - 5 of 5 Posts
Top