[DonKoraan]

Ryobi Router

Hi Gentlemen,

You were correct the two hex headed screws/bolts were under the speed control electronics on one side and the switch gear on the other.

All apart now, bearing procured and just have to put it back together.

Appreciate your respective help and hopefully it will be up and going again later today.

Regards

Derek

 

[DonKoraan]

Hi Gentleman, thanks for your very helpful advice on how to get to the front bearing. I managed to remove the retaining ring (circlip) and the shaft came loose from the bearing. Now I am very careful to which side the bearing must be pressed out. My inclination is that it must be pressed out the side of the armature. Any advice on this will be much appreciated. Regards