Router Forums banner

Ryobi Router Table

4610 Views 3 Replies 2 Participants Last post by  bobj3
Purchased a plunge router from Ryobi and the recommended Ryobi router table.
Problem is that with the router attached to the table and the plunger completely compressed only a small fraction of the bit extends above the table. Any suggestions ! ! !
1 - 4 of 4 Posts
Hi Bill

Some plunge routers will have this error when you mount them into a router table.
Some of the bits are just to short.
You can use/get this item(s) to get around the error.

Router Collet Extension

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/router_collet.html

They do have FREE shipping that will save you a bit of money. :)

But do check your manual 1st. and make sure it's not a error with the router.

One small note***did you take the springs out of the router base ?,some of them just can't compress the springs that much when the springs are in place.

Bj :)
See less See more
Router Collet Extension

Thanks Bj - Ordered two collet extenders, one for 1/4" shank bits and one for the 1/2". Sounds like the solution I needed. Will give them a try as soon as they are shipped. Mr. Bill
You're Welcome Bill

I'm sure you will like them just like I do :)

Why you're wating for them to come in look in your tool box for a good used short 18mm wrench to use on the 1/4" one and a 1 1/16" one for the 1/2" one. ( 1/4" one,I use a short type Snap-On for the one I have,about 4 1/2" long.)

The 1 1/16" is a big wrench but you can get around this by finding one of the Stamped out wrenchs that come with many tools (called a service wrench)
Many have a 1" one as a standard size or metic one that you take to the grinder and open it up to 1 1/16", if you don't have one in the junk box you can find them at the flea market for a buck or two. :)


Bj :)



Bill Flottmann said:
Thanks Bj - Ordered two collet extenders, one for 1/4" shank bits and one for the 1/2". Sounds like the solution I needed. Will give them a try as soon as they are shipped. Mr. Bill
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top