Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
3,765 Posts
Hi John Use 2 wrenches like Phil said. I like the 2 wrench system. I made a set of offset thin wrenches for my Hitachi M12V to work better in the table mounted set up ,it uses the same type system. I cut the wrenches out of cold rolled plate steel and then case hardened them. I am on the road setting up at fairs so I can't send you a picture. I will be back home in a few weeks if you like I can send you a picture of the wrenches I made.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top