has anyone used those saburr tooth burrs??
id like some advice if you would folks,i recently built a copy carver with the mind to make the odd stock,corbell etc.
i had a crack with it yesterday using a peice of african walnut and an old gun stock.
well things didnt go to well with it partly because the stylus i made was slightly out so taking a little too much wood off in places.
so ive been looking for carving bits with matching stylus,s and have only come up with the above mentioned so far.
what appeals to me is that they supply the matching stylus to each bit
but i cant visualize them moveing wood like or as fast as conventional bits.
are they more than capable? or have i got to remove as much wood as possible before useing these burrs?thanks shoot
id like some advice if you would folks,i recently built a copy carver with the mind to make the odd stock,corbell etc.
i had a crack with it yesterday using a peice of african walnut and an old gun stock.
well things didnt go to well with it partly because the stylus i made was slightly out so taking a little too much wood off in places.
so ive been looking for carving bits with matching stylus,s and have only come up with the above mentioned so far.
what appeals to me is that they supply the matching stylus to each bit
but i cant visualize them moveing wood like or as fast as conventional bits.
are they more than capable? or have i got to remove as much wood as possible before useing these burrs?thanks shoot
