Router Forums banner

Sainsmart proverxl 4030 - spindle not starting

608 Views 3 Replies 4 Participants Last post by  jw2170
I have been milling my first project on my Sainsmart proverxl 4030 for over 20 hours.
When I resume my project the next day,
The spindle doesn't always start rotating immediately after clicking send. It's almost as if it's stuck. I can give the spindle a gentle nudge and it starts rotating!
Is my spindle on the fritz already? is this a sign it is wearing out?
1 - 4 of 4 Posts
That doesn't seem normal, and potentially a dangerous situation. I would contact support for your machine, see if they can replace the spindle under warranty.
Welcome to the forum @Jahmelon
Welcome to the forum.

I agree with Mike's comments,
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.