Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
what type of bit do I need to make scallops around the edges of a project? I've got several bits, but have never done scallops. I've been commissioned to do a project for a Ranch, & I was thinkin' the scallops would look the best. Any help would be appreciated.
 

·
Registered
Joined
·
87 Posts
I'd stay away from using a router and use a drum sander in a drill! Practice on a piece of scrap first. It will give you the rustic look I think your customer is looking for. Start with course and stop wiith whatever gives the desired effect.
 

·
Registered
Oliver (Prof. Henry)
Joined
·
2,243 Posts
Here's a simple way to do the scallops using a 45º chamfer bit with a bearing.

 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top