Router Forums banner
1 - 1 of 10 Posts

· Retired Moderator
16,386 Posts
Good video Brian but a good small machinist's square would be faster and at least as accurate and faster. Just loosen the table clamp even to move it and swivel until the square is flush with the bit. I bought a 3" from LV just for jobs like that. I agree with Bob about being out front to rear. I don't know of another method than shimming other than taking it to a machine shop and having the angle corrected.
  • Like
Reactions: Herb Stoops
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.