Router Forums banner
1 - 1 of 5 Posts

· Registered
1,910 Posts
Take either the screws that hold the base plate or the router to a hardware store and match them up. If the plate comes off the table measure the thickness to determine the length you need. If you can't find screws the right length you can get them longer and cut them off. It helps to put a nut on first so that when you cut the screw you can take the nut off and that will clean up the thread end.
1 - 1 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.