Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello, I am new to the forum and of course I have a question. The bearings in my Sears router, Model# 315.17491, were bad and I changed them. Putting it back together I found the springs in the safety switch were bent, and then I lost one. I was looking for a cut sheet of the switch couldn't find on. I couldn't get the switch to lock in the unlocked position. It ran fine if I manually held the switch in the ON position.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top