Router Forums banner
1 - 2 of 7 Posts

· Registered
32 Posts
Discussion Starter · #1 ·
I made this baseplate a few years ago based on plans from a book on routers either by Patrick Spellman or Bill Hylton. It consisits of two bronze bushings with an i.d. to match the bolts. The bolts need to be directly in line with the centerl of the bit and an equal distance from the same.


1 - 2 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.