Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
15 Posts
Mahalo,
Greatings, If I understand you correctly, you intend to use a toungue and groove joint for the door frame and reinforce it with a dowel, That will work fine even with the added wieght of the glass but you will have to install the glass when you assemble the door and you run the risk of cracking the glass while you fit and finish the door. You might want to think about holding the glass in with wood glasing strips and removing the inside sholder of the stile & rail and makig a rabbit cut and ajusting the end cut of your rails and using 2 dowels to reinforce the joint.

I hope you under stand what I'm tring to say.

There are many ways to do it but this is one method I have used.

Good Luck,

Curt
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top