Router Forums banner
1 - 1 of 1 Posts

·
Retired Moderator
Joined
·
16,385 Posts
If you measure the length of the snipe I think you’ll find that it is the same as the distance from the feed roller to the cutter head. The pressure lifts one side slightly until the whole board is under. Some planers come with column locks which are supposed to help but the heads aren’t rigid enough to take all the play out.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top