Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
10 Posts
Hi everyone I thought this would be a good site to look at since I do so much with the router and the router table.I have a mortising attachment for my delta drillpress but I don't use it very much.I use a router to do all my mortising and there is no better way to do it.I use a dw625 by hand with the fence and the other stays in the router table.I use a solid carbide up cut bit to remove the chips hooked up to the shop vac.There is no interupted cut and the walls inside the mortise are smooth.I just under cut the tennons on the corners to match the radious on the mortise.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top