Router Forums banner
1 - 2 of 2 Posts

·
The Router Guys
Joined
·
768 Posts
sailer said:
I live in the Central Florida area and as many of you know,we have been devastated by the recent hurricanes. (three in 1 month) My wife is now wanting me to build hurricane shutters for all the windows. We have been scurrying around trying to get plywood to nail up after each hurricane,and plywood is as scarce as hens teeth before the storm hits.

Does anyone out there know how I can make a jig to make for the router to make the slats needed for the shutters ? :confused:

Any ideas would be greatly appreciated.
What type of tools do you have access to, please advise? Maybe a good email router tip...we also made shutters in the new series of the Router Workshop.
 

·
The Router Guys
Joined
·
768 Posts
sailer said:
I have a 3 1/4hp. Frued router (mounted under a table) and a 1 1/2 hp.router handheld,10" Table saw, 14"Bandsaw,10" sliding compound mitersaw,and various other hand and power tools. All this is set up in my garage,which is cluttered with other houshold junk. I have checked out some of the other sites from previous replies,but they are all for decorative indoor shutters. I would like to built some that are more substantial and practical for outdoor mounting.

Thanks
Sailer
Do you have a miter gauge for the router table? or we could use the tablesaw miter gauge. I going to use the miter gauge for the router on the tip.

Thanks,
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top