Router Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,814 Posts
I don't own one and haven't talked with anyone that has however after looking at the specs and reading the reviews it seems to be a good router at a decent price. I would imagine the sale price would be closer to $100. If you want to buy one now and can't wait; it should do the job. It's too bad the Hitachi/Metabo like it for $99 seems to be discontinued or that you can't wait for the Bosch that's similar goes on sale closer to that price range.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
I don't own one and haven't talked with anyone that has however after looking at the specs and reading the reviews it seems to be a good router at a decent price. I would imagine the sale price would be closer to $100. If you want to buy one now and can't wait; it should do the job. It's too bad the Hitachi/Metabo like it for $99 seems to be discontinued or that you can't wait for the Bosch that's similar goes on sale closer to that price range.
Thanks Marco. I saw some youtube video about metabo plunge base is not very good. Bosch on the other hand is good, but the price a bit higher.
 

·
Registered
Joined
·
1,907 Posts
Does this have a built-in adjuster so that can be adjusted from above the table? If so then it looks like a decent tool. If not then you will have to pay extra (over a hundred) for an adjuster. If that's the case then spend the money and buy one with the adjuster. You may at this point think that you won't use a table. But in reality, you will probably never use it without a table. Having the two bases may look good but not needed in the least.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top