[Woofman]

I'm looking for an easy way to cut the slots in the wood for the rods in the clamp kits I have.

 

[Woofman]

Ed, I have a router set up on the end of my table saw . I tried my drill press set at an a angle to drill the holes but had to do a lot of file work.

 

[Woofman]

Hand Screw Clamps

Thanks Ed, Mike, & Aniceone2hold for the reply and information. I had built a jig for the drill press that pined the side hole so I could move the stock up and down. I'm now going to build a stand alone jig for my router. (I never give up.) It may take a week or two but I'll post a picture of it when it works.--Thanks again----