Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1 Posts
I use 3/4" MDF (CNC cut) as the pattern for some of my work with 8mm Baltic Birch. I pin nail the Birch to the MDF, cut it to shape with a spiral carbide bit and bearing, and then use a 5/16" round over bit to finish the edge. So long as I don't try to make too many copies the MDF holds up well. I'm sure the same technique would work for 3/16" material. Use an 1/8" round over bit and it should work fine.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top