Router Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
756 Posts
I have a Dremel with a pretty small round over bit. Not sure of it's size but it's tiny. It doesn't have a bearing but with a straight edge and a jig to maintain balance and depth it might work.

Another alternative is a an edge plane with a custom blade. I think there have been posts on the Forum about that a while ago. You can search the archives.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top