Router Forums banner
1 - 1 of 24 Posts

· Registered
114 Posts
Freud makes a 1/16” RO with bearing, I have one that I use often.

in your situation, I would skip the router and use either a block plane to chamfer the edge or run the stock between a fence and the spindle on a spindle sander. Both are fast, stone simple, safe, and easy.

in practical terms, the radius is so darn small that a chamfer is virtually the same.
1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.