Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello,
I would like to cut some doors out of [expensive] 15mm furniture board for a camper, i figured I could knock up a template to stick to the furniture board with dbl sided carpet tape and use a router to make a clean plunge cut all the way through following the 'door shaped' template.

Looking on the Trend website there are so many to choose from, I looked at the straight bits but the smallest one that could go to a depth of 15mm was a bit with a 4mm diameter [p/n 3/07X1/4TC] - this will leave me with large gaps around the doors.

Please can anyone point me in the direction of a bit that is a smaller diameter - i don't mind drilling a pilot hole to get it started if necessary ??

thanks in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top