Router Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
3,437 Posts

·
Registered
Joined
·
23,786 Posts
Hi Bruce

You can also use the one you have with just a little rework or make a quick and easy new fence. :)

NOTE**** this is also a great tool when your are using router bits WITHOUT a bearing.
Any bit that removes the flat edge from the stock, :) and a real must for router tables.
e.g. ▼
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_bull.html
http://www.mlcswoodworking.com/shop...arthtml/pages/bt_mold2.html#chair_mold_anchor
Glue Joint Bits
http://www.mlcswoodworking.com/shop...thtml/pages/bt_door.html#door_lip_bits_anchor


see snapshots below ▼

Bj :)

Photos from Woodworking with the Router by Bill Hylton

Woodworking with the Router
http://www.amazon.com/Woodworking-R..._bbs_sr_3/002-5788236-4980042?ie=UTF8&s=books
 

Attachments

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top