hello all,
I am completely new to this so I apologize if it might be a stupid question. Long story short, I bought a laser engraver but I had to buy a router kit for it since I only want to cut acrylics up to 5mm thick (yes it's a Chinese machine lol). I finally finished putting the kit together but it's not working properly. For some reason the spindle only spins every other second instead of just turning on. I followed all the instructions, switched the pin on the board to the spindle position but it just won't work. I tried using lasergrbl and ugs to send the code. Also I created the code using carbide create. I am hoping it's just a setting I am missing.
Here's a video so you all can see. IMG-2109.mp4 - USAupload | Upload Files for free
And the board
Any help would be greatly appreciated!
Thank you
I am completely new to this so I apologize if it might be a stupid question. Long story short, I bought a laser engraver but I had to buy a router kit for it since I only want to cut acrylics up to 5mm thick (yes it's a Chinese machine lol). I finally finished putting the kit together but it's not working properly. For some reason the spindle only spins every other second instead of just turning on. I followed all the instructions, switched the pin on the board to the spindle position but it just won't work. I tried using lasergrbl and ugs to send the code. Also I created the code using carbide create. I am hoping it's just a setting I am missing.
Here's a video so you all can see. IMG-2109.mp4 - USAupload | Upload Files for free
And the board
Any help would be greatly appreciated!
Thank you