Router Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I just bought a 2.2KW Water Cooled Spindle Motor ER20 110V/AC Kit & 110V Inverter VFD 3HP & 80mm Clamp Mount & 75W Water Pump 110V with 6M Pipe & 14pcs / Set ER20 Collet for CNC Router Engraving Milling Machine.

I ordered the wrong kit and this will be my first time trying to build a cnc router. I wanted a ATC kit. Is there anyway I can convert this to a ATC or will I have to buy another kit? Is this even a good spindle kit to begin with? I will be cutting and engraving hard woods.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
What you bought is what most hobbyist cnc users, and many professionals use, if they have a spindle. Many others use routers. An ATC spindle would probably be at least $2500 on up and is generally found on much higher cost machines.

There is no good way to convert it to an ATC.
I saw the more expensive one. I’ll hold off on that since I’m just starting out. Thank you
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top