Router Forums banner
1 - 1 of 1 Posts

·
Marine Engineer
Doug
Joined
·
4,962 Posts
It depends on what you're doing. If you are mortising, upspiral is the way to go. If you are cutting a dado in veneer plywood, downspiral works pretty well.

In general, I have more upspiral than downspiral bits, since they cover a greater range of jobs quite well.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top