Router Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Is there any big difference in using an upcut or downcut spiral bit in the router? I've read about the surface finish and chip ejection, but does it really matter which bit is used in the router for a table application or for using the router by hand? Does the finish matter when making, say, a mortise and tenon?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top