Router Forums banner

Spiral bits

1703 Views 1 Reply 2 Participants Last post by  reible
I think there are two kinds of spiral bits. One cuts so that it pushes the wood chips towards the router motor. The other pushes the chips away from the router motor. So when do you use one, and when do you use the other? If you have a table-mounted router and a bit that pulls the shavings towards the motor, won't that clog thinks up?

Drick
1 - 2 of 2 Posts
Drick said:
I think there are two kinds of spiral bits. One cuts so that it pushes the wood chips towards the router motor. The other pushes the chips away from the router motor. So when do you use one, and when do you use the other? If you have a table-mounted router and a bit that pulls the shavings towards the motor, won't that clog thinks up?

Drick
If you use the Search feature (on the bar that starts with User CP on the far left) you can come up with more comments on spiral bits. One of these can be found at:
http://www.routerforums.com/showthread.php?t=199

After reading these things should be more clear for you, if not post again and someone will provide more information.

Ed
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top