Router Forums banner
1 - 1 of 3 Posts

· Registered
1,702 Posts
Merrell said:
when i cut using a mold trim bit, it always splinters on the corners when i cut across the grain.
how can i prevent this?
i'm using a table router sys
thank you anyone
ejant is correct you need to do an end grain first then rotate the piece and do a with the grain cut followed by the next end grain and lastly the side with the grain.

Now if you still have problems things to check for are a dull bit, taking to heavy a cut but give above mentioned method a try and get back to us if you are still having problems.

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.